Maintenance; Maintenance Safety - Toro Workman HDX-D Operator's Manual

Maintenance

Maintenance Safety

•
Do not allow untrained personnel to service the
machine.
•
Before you leave the operating position, do the
following:
– Park the machine on a level surface.
– Shift the transmission to the N
– Engage the parking brake.
– Lower the cargo bed.
– Shut off the machine and remove the key.
– Wait for all movement to stop.
•
Allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
•
Support the machine with jack stands whenever
you work under the machine.
•
Do not work under a raised bed without the proper
bed safety support in place.
•
Ensure that all hydraulic-line connectors are tight
and that all the hydraulic hoses and lines are in
good condition before applying pressure to the
system.
•
Before disconnecting or performing any work on
the hydraulic system, relieve all pressure in the
system by shutting off the motor, cycling the dump
valve from raise to lower, and/or lowering the cargo
bed and attachments. Place the remote hydraulics
lever in the float position. If the bed must be in
raised position, secure it with the safety support.
•
Carefully release pressure from components with
stored energy.
•
Do not charge the batteries while servicing the
machine.
•
To ensure that the entire machine is in good
condition, keep all hardware properly tightened.
•
To reduce the potential fire hazard, keep the
machine area free of excessive grease, grass,
leaves, and accumulation of dirt.
•
If possible, do not perform maintenance while the
machine is running. Keep away from moving parts.
•
If you must run the machine to perform a
maintenance adjustment, keep your hands, feet,
clothing, and any parts of the body away from
any moving parts. Keep bystanders away from
the machine.
•
Clean up oil and fuel spills.
•
Check the parking brake operation as
recommended in the maintenance schedule and
adjust and service it as required.
•
•
•
position.
EUTRAL
•
•
32
Keep all parts of the machine in good working
condition and all the hardware properly tightened.
Replace all worn or damaged decals.
Never interfere with the intended function of a
safety device or reduce the protection provided
by a safety device.
Do not overspeed the engine by changing the
governor settings. To ensure safety and accuracy,
have an Authorized Service Dealer check the
maximum engine speed with a tachometer.
If major repairs are ever necessary or assistance
is required, contact an authorized Toro distributor.
Altering this machine in any manner may affect the
operation of the machine, performance, durability,
or its use may result in injury or death. Such use
could void the product warranty of The Toro®
Company.