Lubrication; Greasing The Bearings And Bushings - Toro Workman HDX-D Operator's Manual

3. Pivot the top of the hood forward and unplug the
wire connectors from the headlights
4. Remove the hood.
Installing the Hood
1. Connect the lights.
2. Insert the top mounting tabs into the frame slots
(Figure 28).
3. Insert the lower mounting tabs into the frame
slots (Figure 28).
4. Ensure that the hood is fully engaged in the top,
sides, and bottom grooves.

Lubrication

(Figure 28).
Greasing the Bearings and
Bushings
Service Interval: Every 100 hours (lubricate
Grease Type: No. 2 lithium grease
1. Use a rag to wipe the grease fitting clean so that
foreign matter cannot be forced into the bearing
or bushing.
2. With a grease gun, apply grease into the grease
fittings on the machine.
3. Wipe any excess grease off the machine.
Important:
universal shaft bearing crosses, pump grease
until it comes out of all 4 cups at each cross.
The grease fitting locations and quantities are as
follows:
•
Ball joints (4); refer to
•
Tie rods (2); refer to
•
Pivot mounts (2); refer to
•
Steering cylinder (2); refer to
•
Spring tower (2); refer to
39
more frequently in heavy-duty
applications).
When greasing the drive shaft
Figure 29
Figure 29
Figure 29
Figure 29
Figure 29
Figure 30
g010360