Samsung NX60T8111S Service Manual page 57

4. Troubleshooting
Oven Sensor information
Disconnect power
Measure sensor resistance.
Check the connecting condition of harness
(Oven sensor and CN100 of Sub PCB)
Measure resistance of connector CN100
Make sure there is no damage to printed board,
soldered joints or any other parts related to oven
sensor of sub PCB, and repair them or replace sub PCB.
This document can not be used without Samsung's authorization.
"C-20"
[CN100] : Pin 11,13
Ok
Ok
END
< oven sensor >
No
* reconnect
No
* repair damaged
CN100
57
Replace the oven sensor.
END
Harness or replace