Table of Contents
Advertisement
Connecting the unit
6.5.2 Connecting softened drinking water to both connections
INFORMATION
Prerequisite Water pressure complies with specifications (see "Unit and
36
2. Flush the connection lines thoroughly.
3. Insert dirt filters into the water connections on the unit.
4. Connect the drinking water connection line to the unit.
5. Connect the connection line for softened drinking water to the unit.
6. Open the tap water valves and check the threaded connectors for
leaks.
7. Fill out the Start-up operation report.
Image: Water connection
a Connection line
b Softened drinking water
c Drinking water
If only softened drinking water is available at the installation site, use
a T-piece to connect both water connections on the unit to each
other.
Each unit must be connected individually.
Do not join the connection lines.
connection data")
Backflow preventer installed
Pressure-tight connection line suitable for drinking water is available
1. Connect the connection line to the tap for softened drinking water
using a seal.
2. Flush the connection line thoroughly.
3. Insert dirt filters into the water connections on the unit.
4. Connect T-piece to the unit.
Installation instructions
e
f
d
d Backflow preventer
e Softened drinking water
connection
f Drinking water connection
a
b
c
Advertisement
Table of Contents
