Data Multiplex Unit Control - Panasonic WV-CU360C Operating Instructions Manual

Housing/AUX Control
When your system includes a camera housing, the
defroster and wiper equipped in it are controlled. When a
Receiver is installed in the system, an auxiliary device con-
nected to it such as a buzzer or lamp will be also con-
trolled.
8 Defroster
Press the DEF/AUX 2 button to enable or disable defroster
operation for the selected camera. The DEF/AUX 2 indica-
tor next to the button is lit while it is in operation.
8 Wiper
Press the WIPER/AUX 1 button to enable or disable wiper
operation for the selected camera. The WIPER/AUX 1 indi-
cator next to the button is lit while it is in operation.
Note: To prevent early wiper wear, be sure to turn off the
wiper whenever it is not needed, or before selecting
another camera for viewing.
8 Auxiliary 1/2
1. Press the SHIFT button to turn the SHIFT indicator on.
2. Press the WIPER/AUX 1 or DEF/AUX 2 button to
enable or disable the auxiliary function for the selected
camera. The respective indicator next to the button is lit
while it is in operation.
SHIFT
Note: Auxiliary control may be ignored while zooming,
focusing or panning/tilting is in operation.
28
DEF
AUX 2
WIPER
AUX 1
DEF
AUX 2
WIPER
AUX 1

Data Multiplex Unit Control

When more than one Data Multiplex Unit are connected
with the controller as shown in System Connection Example
2 on page 14, you can select a camera directly with the
camera number, without typing a system unit address.
Setting
Camera numbers are specified by the UNIT switch or in the
setup menu for the WJ-MP204C.
For further details, refer to the manual included with the
Data Multiplex Unit.
Unit Address
of WJ-MP204C
1 1, 2, 3, 4
2 5, 6, 7, 8
3 9, 10, 11, 12
4 13, 14, 15, 16
When more than one controller is connected in the system,
remember settings are needed for the MODE DIP switch
and CONTROLLER NO. switch of the controllers as
described on page 16.
Camera Selection
1. Press a camera number using the numeric buttons.
MON
LOGOUT
ESC
2. Press the CAM/SET button.
CAM
Camera Number
CAM
SET
SET