Controller Setup Procedures (For Wj-Sx350); Prior To Setup; Buttons And Controls Used In Setup - Panasonic WV-CU360C Operating Instructions Manual

CONTROLLER SETUP PROCEDURES (For WJ-SX350)

To display the setup menus for the WV-CU360C System Controller on the LED display, set the MODE switch and power up the
controller as described below.

Prior to Setup

Do the following before entering the setup mode.
1. Confirm that all necessary connections and switch set-
tings are complete.
2. With the power turned off, move bit #6 of the MODE
switch on the rear to ON (administrator) position.
3. Supply power to the controller.
4. Turn on the power of cameras and other system units.
5. The LCD displays [SEtUP]. The controller is ready to
enter the setup mode.
Operator mode
1 2 3 4 5 6 7 8
MODE
When setup is completed, restore the switch to its original
position.
1. With the power turned off, move bit #6 of the MODE
switch on the rear to OFF (operator) position.
2. Supply power to the controller.
60
OFF
ON
1 2 3 4 5 6 7
MODE
Administrator mode
DC 9V IN
Buttons and Controls used for Setup
The following buttons and joystick operations are used for
setup.
0 9
CAM
SET
MON
ESC
OFF
ON
8
L R
DOWN
UP
L R
UP
R
DOWN
UP
L R
DOWN
Numeric buttons: To select a parameter
CAM/SET button: To execute modes and
parameters
To enter a submenu
MON/ESC button: To return to the previous
menu
Up: To select a setup menu
Down: To select a setup menu
Left: To decrease the parameter
Right: To increase the parameter