Camera Control - Panasonic WV-CU360C Operating Instructions Manual

Camera Control

Cameras and their peripherals are controlled from the WV-
CU360C as follows. Some of the descriptions may not be
applicable if they refer to devices not equipped in your sys-
tem.
The operating procedures on the following pages assume
that you have selected a system unit and a monitor.
Pan/Tilt Control
Proceed as follows to control a combination camera or an
ordinary camera mounted on a pan/tilt head.
1. Move the pan/tilt head in the desired direction with the
joystick controller.
2. To slowly move the pan/tilt head, move the joystick
while holding down the SLOW button.
Lens Control
This allows you to control a motorized lens.
1. Press the FOCUS NEAR or FOCUS FAR button to
adjust the lens focus while watching the monitor.
If you are using a camera with an auto focus feature,
the lens focus can be automatically adjusted by press-
ing the FOCUS NEAR and FOCUS FAR buttons simul-
taneously.
NEAR
26
Joystick
SEQ PAUSE
SLOW
FOCUS
FAR
AUTO FOCUS
2. Press the ZOOM TELE button to optically bring the
object closer, or press the ZOOM WIDE button to opti-
cally widen the scene.
ZOOM
WIDE
3. Press the IRIS CLOSE button to close the iris, or the
IRIS OPEN button to open the iris.
If the IRIS CLOSE and IRIS OPEN buttons are pressed
simultaneously, the iris is reset to the default.
CLOSE
IRIS RESET
Home/Preset Position
The camera moves to the preset position or back to the
home position, and the picture of the camera in that posi-
tion appears on the monitor.
1. Press the HOME/PRESET button to move the camera
back to the home position.
HOME/PRESET
PROGRAM
PRESET
2. Select a preset position number using the numeric but-
tons, then press the HOME/PRESET button to move the
camera to the position.
MON
LOGOUT
ESC
TELE
IRIS
OPEN
HOME/PRESET
CAM
PROGRAM
SET
PRESET