Controller Setup - Panasonic WV-CU360C Operating Instructions Manual

Controller Setup

Set up the baud rate and parity check mode for the controller while observing the LED on the front panel.
Menu
Selection
No
OK
Move Joystick
UP and down
to select
L R
DOWN
UP
L R
Administrator Authorization
1. Press the CAM/SET button while [SEtUP] is displayed.
The [- - - - -] prompt appears.
2. Enter a password with the numeric buttons, then press
the CAM/SET button.
The default setting is [12345].
3. If the password entered is valid, [SPEED] appears. If
password entry failed, the menu returns to [SEtUP].
Baud Rate
In this menu, the communication speed (bps: bits per sec-
ond) is selected. The communication speed should match
that of the WJ-FS616/FS616C.
1. Display [SPEED] and press the CAM/SET button twice.
2. Select a parameter entering a bracket-enclosed num-
ber, e.g., (3), moving the joystick to right and left, or
pressing the [+] and [–] buttons.
The default setting is 9 600 bps.
(1) 2 400: 2 400 bps
(2) 4 800: 4 800 bps
(3) 9 600: 9 600 bps
(4) 19 200: 19 200 bps
47
Setup Menus
LED Display Reading
Setup
Administrator
Password
Prompt
blinking
Speed
Parity
Function
CAM
Initial
Display
SET
Authorization
Press
twice
Baud Rate
(bps)
CAM
SET
MON
Parity Check
ESC
Note: Selecting a slower rate (e.g., 2 400 bps) will delay
the response time (e.g., the time until an activated
alarm is reset).
3. Press the CAM/SET button to validate the selection.
4. Press the ESC button to go back to the previous menu.
Parity
In this menu the parity check mode is selected.
1. Display [PrtY] and press the CAM/SET button twice.
2. Select a parameter with the joystick.
The default setting is None.
n: None
E: Even parity
3. Press the CAM/SET button to validate the selection.
Parameter Selection (default*)
LED prompts you to enter pass-
word
Enter a 5-digit password,
press (12345*)
CAM
SET
(1) 2 400 (2) 4 800 (3) 9 600*
(4) 19 200
(1) None* (2) Even