Controller Setup Procedures (Ps Data); Prior To Setup; Buttons And Controls Used In Setup - Panasonic WV-CU360C Operating Instructions Manual

CONTROLLER SETUP PROCEDURES (PS
To display the setup menus for the WV-CU360C System Controller on the LED display, set the MODE switch and power up the
controller as described below.

Prior to Setup

Do the following before entering the setup mode.
1. Confirm that all necessary connections and switch set-
tings are complete.
2. With the power turned off, move bit #6 of the MODE
switch on the rear to ON (administrator) position.
3. Supply power to the controller.
4. Turn on the power of cameras and other system units.
5. The LCD displays [SEtUP]. The controller is ready to
enter the setup mode.
When setup is completed, restore the switch to its original
position.
1. With the power turned off, move bit #6 of the MODE
switch on the rear to OFF (operator) position.
2. Supply power to the controller.
17
Data)
•
Buttons and Controls used for Setup
The following buttons and joystick operations are used in
the setup operation. There are three ways to select a para-
meter, but the following pages only describe the selection
by use of the joystick. Instead of operating the joystick, you
can enter the number enclosed in brackets with the numer-
ic keys or press the plus and minus buttons.
Numeric buttons: To select a parameter
0 9
CAM/SET button: To confirm the selected
CAM
SET
MON/ESC button: To return to the previous
MON
ESC
Up: To select a setup menu
L R
DOWN
UP
Down: To select a setup menu
L R
UP
STILL
or
R
Left: To decrease the parameter
–
DOWN
UP
EL-ZOOM
or
Right: To increase the parameter
L R
+
DOWN
To enter a password or
parameter
menu, selected parame-
ter or entered password
To enter a submenu
menu