Operating Procedures (For System 850); Login & Logout - Panasonic WV-CU360C Operating Instructions Manual

OPERATING PROCEDURES (For System 850)

Note: This section describes only some important operations such as login, logout, and different operations from the front
panel of the System 850. Please refer to the manual included with the System 850 for further information on camera
selection, monitor selection and so forth.
Login & Logout
Login
1. Turn on the power switches of all system components.
2. Turn on the power of the WV-CU360C System Controller
by connecting the AC adapter to the AC outlet.
The OPERATE indicator lights up and "NO USER" will
appear on the LED display of the System Controller.
3. Enter your registered Operator ID number (up to 5 dig-
its) using the numeric buttons, then press the [CAM-
ERA (ENTER)] button. The underline appears on the
LED display.
AUX1 OFF
AUX2 OFF
DEF OFF
SHIFT
4. Enter your registered Password (up to 5 digits) using
the numeric buttons, then press the [CAMERA
(ENTER)] button.
If the operator ID and password entered are valid, the
LED will display "READY".
75
PROGRAM
CAM ID GEN PRESET
1 2 3
AUX1 ON WIPER
MON STATUS ALL
4 5 6
CALL
PRESET
AUX2 ON
7 8 9
DEF ON
CLEAR
CAMERA
( ESC )
( ENTER )
0
AUTO
PAN
CAM ID
1
AUX1 OFF AUX1 ON
MON STATUS
4
AUX2 OFF AUX2 ON
7
DEF OFF DEF ON
SHIFT
Note: If login has failed (operator or password error), the
PROHIBITED indicator on the controller will light up and
"NO ACCESS" will blink on the LED display for about 3
seconds. Then the login procedure returns to the start.
Logout
1. While holding down the LOG OUT button, press the
[CAMERA (ENTER)] button .
"NO USER" is displayed on the LED display.
LOG OUT
PROGRAM
GEN PRESET
2 3
WIPER
ALL
5 6
CALL
PRESET
8 9
CLEAR
CAMERA
( ESC )
( ENTER )
0
AUTO
PAN
CAMERA
(ENTER)
AUTO
PAN