Camera Control; Pan/Tilt Control; Manual Operation; Lens Control - Panasonic WJ-SX150 Series Addendum

CAMERA CONTROL

Note: This section describes the terminal mode. To operate
in the PS·Data mode, refer to the operating instructions.
Buttons and control for cameras or camera site accessories
are located on the 3D joystick unit and the right side of
main unit.
Included are zoom control, focus control, iris control, preset
and pan/tilt controls.
Normally, combination cameras equipped with the specific
feature or a WV-RC100 or WV-RC150 Receiver are required
to utilize these functions.
Note: Refer to the cameras' operating instructions whether
to confirm that each function is available.

■ Lens Control

This function is available when specified lens, with motor-
ized zoom/focus functions, is mounted on the camera, and
the lens selection (DC/VIDEO) on the camera is set to DC.
1. Select the desired monitor and camera. (Refer to p. 3
Monitor Selection and p. 3 Camera Selection.)
2. Press the FOCUS FAR or NEAR button while watching
the monitor. The lens focus is adjusted to obtain a
sharply focused image.
Note: Pressing the B button or top button of 3D joystick
unit can also set the lens focus automatically.
Top button
4
FAR
FOCUS
NEAR
3. To adjust the lens zoom, move the zoom wheel con-
troller to the right (TELE) or left (WIDE).
WIDE
4. Press the IRIS OPEN or CLOSE buttons to open/close
the lens iris. The lens iris is adjusted by these buttons to
obtain the proper image exposure.
Note: To set the lens iris automatically, press the A but-
ton of 3D joystick unit.

■ Pan/Tilt Control

● Manual Operation
1. Select the desired monitor and camera. (Refer to p. 3
Monitor Selection and p. 3 Camera Selection.)
2. Move the 3D joystick to move the pan/tilt head towards
the desired direction.
● Auto Panning
Refer to p. 8 Camera Panning Function for how to oper-
ate.
TELE
Zoom wheel controller
OPEN
IRIS
CLOSE