Wj-Hd200 Series Control (Terminal Mode) - Panasonic WJ-SX150 Series Addendum

WJ-HD200 SERIES CONTROL (TERMINAL MODE)

Matrix switcher can control the following functions of Digital
Disk Recorder WJ-HD200 Series. The following is the pro-
cedure of WJ-HD200 Series SETUP MENU.
Notes:
• The following operating procedures are for the terminal mode.
If you are using a PS·Data system controller, refer to p. 36.
• When a Multiplexer board is installed in the matrix switch-
er, you can neither connect nor control a WJ-HD200 Series
recorder. You need to remove the board from the matrix
switcher.
■ Displaying WJ-HD200 Series
SETUP MENU
The operations are the same as WJ-HD500 Series. (Refer to
p. 18.)
■ Controlling Digital Disk
Recorder WJ-HD200 Series
The following are the operating procedures of WJ-HD200
Series via system controller.
Note: Refer to the operating instructions of Digital Disk
Recorder WJ-HD200 Series for details.
● Recorder Mode
The operations are the same as WJ-HD500 Series. (Refer to
p. 19.)
● Multiscreen Segment Switching
The operations are the same as WJ-HD500 Series. (Refer to
p. 19.)
Note: 4C-, 4D-, 7-, 10-, 13- and 16-segment multiscreen
display patterns are unavailable.
● Normal Playback
The operations are the same as WJ-HD500 Series. (Refer to
p. 19.)
Note: You cannot skip to the previous/next record.
30
● Manual Recording
The operations are the same as WJ-HD500 Series. (Refer to
p. 20.)
Note: Refer to WJ-HD200 Series Operating Instructions for
details and other recording modes.
● Stopping REC ONLY Alarm
Recording
The operations are the same as WJ-HD500 Series. (Refer to
p. 20.)
● Search Playback
You can search playback images using the ALARM
RECALL table or the SEARCH table.
Every time you press the SEARCH/T&D SEARCH button,
the display will change as follows.
Live image → Date-and-time entry form → ALARM RECALL
table → Live image
• Date-and-time Search Playback
The recorded images can be searched for through the date
and time.
1. Enter the recorder mode. (Refer to p. 19 Recorder
Mode.)
2. Press the SEARCH/T&D SEARCH button. The date-and-
time entry form will appear on the center of the monitor.
SEARCH
YYYY/MM/DD HH:MM
2002/05/07 19:32
Note: The factory default setting is the current date and
time.