System Status Table - Panasonic WJ-SX150 Series Addendum

2. Perform desired operations.
q Moving the clock display
Move the 3D joystick while holding down the F1 but-
ton. (1) will move to the desired direction.
w Moving the Camera Title Display
Move the 3D joystick while holding down the F2 but-
ton. (2) will move to the desired direction.
e Moving the Event Display
Move the 3D joystick while holding down the F3 but-
ton. (3) will move to the desired direction.
r Moving the Monitor Status*
Move the 3D joystick while holding down the F4 but-
ton. (4) will move to the desired direction.
* Monitor number, controller number and monitor
mode
● Moving All the Items
1. Press the MENU button repeatedly until "OSD Position"
appears on the LCD.
OSD Position
Clock Cam Event Mon
2. Hold down the SHIFT button. The LCD display will
become as follows.
OSD Position
All
3. Move the 3D joystick while holding down the F1 button.
(1), (2), (3), and (4) (refer to p. 11) will move to the
desired position.

■ System Status Table

The table shows the current system status.
1. Select the desired monitor. (Refer to p. 3 Monitor
Selection.)
12
2. Press the MENU button repeatedly until "System Status"
3. Press the F1 button.
The columns in the table indicate the states as shown in the
figure.
003
003
* R0 to R4 shows the following.
** When this parameter is selected, a recorder number is
4. To close the SYSTEM STATUS table, press the F2 but-
5. To exit the mode, press the MON (ESC) button.
appears on the LCD.
The SYSTEM STATUS table will appear on the active
monitor as shown in the figure.
SYSTEM STATUS
MON CAM MODE
1 01 T01
2 99 SPOT
3 04 ALARM
4 R1 RECORDER
MON: Monitor number
CAM: Logical camera number (01 to 99)
Recorder number (R0 to R4)*
"– –" indicates that no camera is being
selected.
MODE: Lists the display mode on the
monitors.
SPOT: Spot mode
Tnn: Tour Sequence mode (nn is the
tour sequence number.)
CAM: Camera Setup mode
SET: WJ-SX150A Setup mode
ALARM: Alarm Active mode
ACK: Alarm ACK mode
VLD H: Video Loss History Table
ALM H: Alarm History Table
SYS S: System Status Table
RECORDER: Recorder mode**
KB: Lists the system controller name
(K1 to K4) or PSD.
OPE: Lists the operator number
PRI: Lists the priority number
Recorder number
R0
R1
R2
R3
R4
displayed in the CAM area.
ton.
KB OPE PRI
K1 12345 30
K2 2 2
K4 4 1
PC 30 1
Recorder
Master recorder
Slave 1 recorder
Slave 2 recorder
Slave 3 recorder
Slave 4 recorder