Video Loss History Table - Panasonic WJ-SX150 Series Addendum

TIME-LAPSE VCR CONTROL
A time-lapse VCR is operable with the system controller,
while connecting to the matrix switcher.
Notes:
• Before the use, it is necessary to install the
Multiplexer board in the matrix switcher, connect
the matrix switcher to the digital disk recorder, and
configure the system
Administrator Console, OSD SETUP MENU, and
time-lapse VCR's SETUP MENU. (Refer to the oper-
ating instructions of matrix switcher.)
• You cannot control non-Panasonic time-lapse VCRs
from system controllers.
The following is the procedure of a non-Panasonic model
time-lapse VCR.
■ Controlling the Time-lapse VCR
● Multiscreen Segment Switching
The operations are the same as WJ-HD500 Series.
(Refer to p. 19.)
MONITOR DISPLAY CONTROL (PS·DATA)
The operations are the same as System Controller WV-
CU360C/CJ.
(Refer to the operating instructions of matrix switcher for
how to operate.)
However, the following operations differ from System
Controller WV-CU360C/CJ.
■ On-screen Display (OSD)
Control
Refer to WV-CU950/650 Operating Instructions.

■ Video Loss History Table

Refer to WV-CU950/650 Operating Instructions.
[NON-PANASONIC MODELS] (TERMINAL MODE)
MUX
through WJ-SX150A
Note: 7-, 10-, and 13- segment multiscreen display pat-
terns are unavailable.
● Normal Playback
1. Enter the recorder mode. (Refer to p. 19 Recorder
Mode.)
2. Do the playback procedure using the buttons on the
front panel. (Refer to the time-lapse VCR's operating
instructions for how to operate.)
3. Press the PLAY/PAUSE button. The playback image will
appear on the monitor.
4. To display the spot picture, press the numeric buttons
corresponding to the desired camera number, then
press the CAM (SET) button. Then, the active monitor
number will appear on the LCD. (Refer to p. 20 Normal
Playback for the illustration.)
● Other Operations
Refer to the time-lapse VCR's operating instructions for how
to operate.
35