I Alarm Modes; I Video Loss - Panasonic WJ-SX650/G Operating Instructions Manual

I Alarm Modes

The following alarm modes ("Display Mode" settings) are
available. (Alarm mode follows the setting of "Display
Mode".)
G Spot
The image of associated camera will be displayed on the
monitor. Preset position or auxiliary control will be activated.
The following alarm modes (=patterns to display alarm pic-
tures on a monitor) are available. (Regardless of alarm
modes, alarms occur to all the associated cameras.) The
alarm mode setting is performed in "Alarm" – "Alarm Mode"
of WJ-SX650 Series Administrator Console or the ALARM
menu of SETUP MENU. The following illustration is the
example in which alarms occur in the order of Alarm 1 _
Alarm 2 _ Alarm 3 _ Alarm 4.
• Sequence mode
Alarm pictures are displayed sequentially (from the newest
alarm picture) on the associated monitor.
Alarm 4
• Earliest mode
The earliest alarm picture is displayed on the associated
monitor.
Alarm 1
• Latest mode
The latest alarm picture is displayed on the associated
monitor.
Alarm 4
68
Alarm 3
Alarm 2 Alarm 1
G Tour Sequence
Tour sequence is activated on the associated monitor.
G Group Sequence/Preset
Group sequence is activated on the associated monitors.
G OFF
Only the alarm information is displayed on the associated
monitor. Alarm does not occur to monitors and cameras.
Notes:
• When a tour sequence, group sequence, or group pre-
set is activated as an alarm event, the earlier alarm
event on the monitor will be reset.
• When 33 or more alarms (spot mode) occur to a moni-
tor, older alarms will be reset chronologically.
• After occurrence, the same alarm will be suspended for
5 seconds.
• By the alarm schedule setting, alarm events can be
deactivated in the specified periods. The alarm sched-
ule setting is performed in "Alarm" – "Alarm Event" of
WJ-SX650 Series Administrator Console.
I
Video Loss
To display the video loss information on associated moni-
tors and save the video loss history without making alarms
occur to monitors and cameras, set "Display Mode" to OFF.
Note: If Alarm A ("Display Mode" is OFF) occurs while
Alarm B's ("Display Mode" is Spot, Tour Sequence or
Group Sequence) are being activated, the Alarm A
information will be displayed on the monitor after all
Alarm B's have been reset.