Patrol Learn And Play - Panasonic WJ-SX550C Operating Instructions Manual

Direct Preset Setup
The following function requires the use of cameras
equipped with the specific feature.
This function enables registering of preset position number
without opening the camera setup menu.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Move the camera to the preset position to be regis-
tered by moving the Joystick Controller and ZOOM,
FOCUS Controls.
3. Select the PrePOSI Setup (B5) Menu on the LCD dis-
play by pressing the Direction buttons.
4. Select the desired preset position number by pressing
the Numeric keys, then press the Function (F1) button
to register the position.
B5
PrePOSI SetUp
5 5
Note: If the position number entered has been regis-
tered previously, the old position will be overwritten
by the new one.
106
1 2 3
4 5 6
7 8 9
0
MON CAM
ESC SET
Set
F1 F2 F3 F4

Patrol Learn and Play

The following function requires the use of cameras
equipped with the specific feature.
A routine of manual operations can be stored for a specific
time and later reproduced repetitively.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Select the Patrol Learn (B4) Menu on the LCD display
by pressing the Direction buttons.
B4
PatrolLearn
Play Learn Stop
F1 F2
3. Press the Function (F2) button to start Patrol Learn .
"LEARNING" appears on the active monitor.
4. Operate the camera manually. Operations data is
stored.
The stored data is as show below.
Pan/Tilt, Lens Iris, Focus, Zoom and Preset Position
5. Press the Function (F3) button to end the storage.
To reproduce the stored data, follow the procedure shown
below.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Select the Patrol Learn (B4) Menu on the LCD display
by pressing the Direction buttons.
B4
PatrolLearn
Play Learn Stop
F1 F2
3. Press the Function (F1) button to reproduce the stored
Patrol function.
4. Press the Function (F3) button to end the reproduction.
F3 F4
F3 F4