Patrol Learn And Play - Panasonic System 850 Operating Instructions Manual

Changing to Black and White
Pictures
The following function is available only when specified cam-
eras having a color-black and white switching feature are
used.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Press the [F6] key two times.
"B/W Change" as shown in the figure will appear on
the LCD display of the controller.
F.1
ARM
1 2
T&D CAM ID
ALM S VLD S
4 5
( ALARM )
MSTATUS
ALM H VLD H
7 8
0
SHIFT BLK
3. Press the [1] key to change the picture from color to
black and white on the active monitor.
4. Press the [2] key to change black and white to color
picture on the active monitor.
5. To exit from the mode, press the [CLEAR (ESC)] key.
Note: When the black and white parameter is set
AUTO in the camera setup menu, this function is
disabled.
86
INFORMATION
B/W change
1:On
2:Off
F.2 F.3 F.4 F.5 F.6
CMENU CMENU CAM
OFF ON FUNC
IRIS
3 CLOSE OPEN
LOGOUT AREA
GEN
AUX1 OFF AUX1 ON WIPER
SYS S
CALL PGM DEFAULT
6
PRESET PRESET FOCUS
ALL
AUX2 OFF AUX2 ON
NEAR FA R
9 C A M DIGITAL
P O S I OUT
DEF OFF DEF ON
AUTO FOCUS
ZOOM
CAMERA
CLEAR
(ENTER)
WIDE TELE
(ESC)
EXIT AUTO PAN

Patrol Learn and Play

The following function requires the use of cameras
equipped with this specific feature.
A routine of manual operations can be stored for a specific
time and later reproduced repetitively.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Press the [F6] key three times.
"Patrol Learn" as shown in the figure will appear on the
LCD display of the controller.
INFORMATION
Patrol Learn
1:Play
2:Learn(2+Enter)
3:Stop
F.1 F.2
ARM
1 2 3
T&D CAM ID GEN
ALM S VLD S SYS S
4 5 6
( ALARM )
MSTATUS ALL
ALM H VLD H
7 8 9
0
CLEAR
(ESC)
SHIFT BLK EXIT
To save the patrol sequence, follow the procedure
shown below.
q Press the [2] key, then press the [CAMERA
(ENTER)] key to start Patrol Learn.
w Operate the camera manually. Operations data
(patrol sequence) is stored.
e Press the [3] key to end the learning.
To reproduce the stored data, follow the procedure
shown below.
q Press the [1] key to reproduce the stored Patrol
function.
w Press the [3] key to end the reproduction.
3. To exit from the mode, press the [CLEAR (ESC)] key.
F.3 F.4 F.5 F.6
CMENU CMENU CAM
OFF ON FUNC
IRIS
CLOSE OPEN
LOGOUT AREA
AUX1 OFF AUX1 ON WIPER
CALL PGM DEFAULT
PRESET PRESET FOCUS
AUX2 OFF AUX2 ON
NEAR FA R
C A M DIGITAL
P O S I OUT
DEF OFF DEF ON
AUTO FOCUS
ZOOM
CAMERA
(ENTER)
WIDE TELE
AUTO PAN