Panasonic WJ-SX550C Operating Instructions Manual page 102

Camera Power and Housing Control
For remote camera power operation, a 24 V AC powered
camera must be installed in the housing.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection.
2. Select the Cam-Power Housing (B2) Menu on the LCD
display by pressing the Direction buttons.
B2
Cam-Power Housing
3. Press the Function (F1) button to toggle the camera
power on and off.
F1
4. Press the Function (F3) button to toggle the housing
wiper on and off.
F3
5. Press the Function (F4) button to toggle the housing
5
defroster on and off.
F4
Caution
To prevent premature wearing of the wiper blades,
be sure to turn off the wiper when it is not needed or
before selecting another camera for viewing.
107
Cam Wiper Def
F1 F2 F3 F4
Cam
On:
Cam
Off:
Wiper
On:
Wiper
Off:
On: Def
Off: Def
Running a Sequence
Program Sequence
The following functions are available only if a Program
Sequence has been previously established through the Set
Up Menu.
As described on page 69, the Program Sequence can dis-
play up to 128 cameras in a predetermined series on a
selected monitor.
1. Select the desired monitor.
Refer to the Monitor Selection.
2. Select 0 by pressing the Numeric key.
A1
Camera 01
Monitor 16
1
4
7
MON
ESC
Camera 01
Monitor 16
3. Press the FORWARD SEQ button to run the assigned
Program Sequence in forward direction on the active
monitor.
FORWARD
P-Seq
Monitor 16
SLW FST
2 3
5 6
8 9
0
CAM
SET
0
SLW FST
SEQ