Panasonic WJ-SX550C Operating Instructions Manual page 99

Pan/Tilt Control (Camera Position
Operation)
The following function is available only when the Mode
Selection Switch located on the rear of the controller is set
to CAM-P Mode, and requires the use of cameras
equipped with the specific feature.
1. Select the desired monitor.
Refer to the Monitor Selection.
2. Select the CAM-P (D5) Menu on the LCD display by
pressing the Direction buttons.
D5
CAM-P Menu
Set Clear Test Mode
3. Press the Function (F4) button to display the menu
shown below.
CAM-P Mode Off
On
4. Select CAM-P Mode On by pressing the Function (F1)
button repeatedly.
CAM-P Mode On
Off
5
Note: Selecting On mode on the LCD display enables
the MON (ESC) key to execute the selection.
When selecting the monitor, enter the desired mon-
itor number by pressing the Numeric keys, and
then press the Function (F1) button instead of the
MON (ESC) key while the Monitor Selection (A1)
Menu is displayed.
104
F1 F2 F3 F4
Exit
F1 F2 F3 F4
Exit
F1 F2 F3 F4
5. Select the desired camera position number by pressing
the Numeric keys, then press the MON (ESC) key to
move the camera to the preset position.
The selected camera position appears on the active
monitor.
1 2
4 5
7 8
0
MON
ESC
6. Press the Function (F4) button to return to the CAM-P
Menu.
Note: To to use the above functions, it is necessary to
register the preset position number with the cam-
era number.
Refer to the Mode Selection Switch Setting on
page 54 and the Camera Position Number Setting
on page 123 for further details.
3
6
9
CAM
SET