Connecting The Network Configurator To The Network - Omron NX Series User Manual

9 Tag Data Link Functions
The specified values for detailed parameters will be displayed. Change the values as required.
Connection names are automatically created using the following rule.
default_N (where N is a 3-digit number (001, 002, etc.) starting from 1)
Additional Information
The following dialog box will be displayed if a target device that does not have I/O data is drop-
ped.
Before dropping again, refer to the manual of the applicable device and create the I/O data (i.e.,
output tag sets) required to create a connection.
3
After you complete the settings, click the Regist Button to create the connection. When the
connection is completed, the input tag set box and the output tag set box will be blank. You can
continue to create another connection by selecting a next connection I/O type and setting a tag
set.
9-2-8

Connecting the Network Configurator to the Network

This section describes how to connect the Network Configurator to the network.
Precautions for Correct Use
Connection may not be possible if the following settings are made on an NJ/NX-series Control-
ler on the connection path or on a connection destination NJ/NX-series Controller. If connection
fails, check the following settings. For the details on the settings, refer to CIP Message Server
on page 7-15 and Packet Filter on page 7-7.
• The Do not use Option is selected for the CIP message server.
• The Use Option is selected for Packet Filter.
Additional Information
Although the NX-series EtherNet/IP Unit provides two EtherNet/IP ports, the Network Configu-
rator treats these two ports as two different Units and connects them individually.
9-48
NX-series EtherNet/IP Unit User's Manual (W627)