Omron NX Series User Manual page 248

10 CIP Message Communications
General
status
code (hex)
06 Partial transfer
07 Connection lost
08 Service not supported
09 Invalid attribute value
0A Attribute list error
0B Already in requested
mode/state
0C Object state conflict
0D Object already exists
0E Attribute not settable
0F Privilege violation
10 Device state conflict
11 Reply data too large
12 Fragmentation of a primi-
tive value
13 Not enough data
14 Attribute not supported
15 Too much data
16 Object does not exist
17 Service fragmentation se-
quence not in progress
18 No stored attribute data
19 Store operation failure
1A Routing failure (request
packet too large)
1B Routing failure (response
packet too large)
1C Missing attribute list entry
data
1D Invalid attribute value list
1E Embedded service error
1F Vendor specific error
10-20
Status name
Only part of the expected data was transferred.
The message connection was lost.
The requested service was not supported or was not defined for this
object class/instance.
Invalid attribute data was detected.
An attribute in the Get_Attribute_List or Set_Attribute_List response
has a non-zero status.
The object is already in the mode/state being requested by the serv-
ice.
The object cannot perform the requested service in its current mode/
state.
The requested instance of object to be created already exists.
A request to modify a non-modifiable attribute was received.
A permission/privilege check failed.
The device's current mode/state prohibits the execution of the re-
quested service.
The data to be transmitted in the response buffer is larger than the
allocated response buffer.
The service specified an operation that is going to fragment a primi-
tive data value, i.e. half a REAL data type.
The requested service did not supply enough data to perform the
specified operation.
The attribute specified in the request is not supported.
The service supplied more data than was expected.
An object that does not exist was specified for the requested serv-
ice.
The fragmentation sequence for this service is not currently active
for this data.
The attribute data of this object was not saved prior to the requested
service.
The attribute data of this object was not saved due to a failure dur-
ing the attempt.
The service request packet was too large for transmission on a net-
work in the path to the destination. The routing device was forced to
abort the service.
The service response packet was too large for transmission on a
network in the path from the destination. The routing device was
forced to abort the service.
The service did not supply an attribute in a list of attributes that was
needed by the service to perform the requested behavior.
The service is returning the list of attributes supplied with status in-
formation for those attributes that were invalid.
An embedded service resulted in an error.
A vendor-specific error occurred. The Additional Code Field of the
error response defines the error. This is a general error code that is
used only for errors that do not correspond to any of the error codes
in this table and are not in an object class definition.
Description of status
NX-series EtherNet/IP Unit User's Manual (W627)