Omron H5CC Manual page 33

Timer/Twin Timer Selection Mode (Function Selection)
Select whether the H5CC is used as a timer or a twin timer in timer/twin timer selection mode.
Power ON
0.00
0.00
* 2 * 1
UP1+UP6 or DW1+DW6
UP1+UP6 or DW1+DW6
(Press and hold for 2 s)
(Press and hold for 2 s)
func
tim
*1. When the mode is changed to timer/twin timer selection mode, the present value is reset and output turns OFF.
*2. Setting changes made in timer/twin timer selection mode are enabled when the mode is changed to run mode.
If the configuration is changed, the set values and set time are initialized. To initialize the set values and set time, set tim (timer) → twn (twin
timer) or twn (twin timer) →tim (timer) in timer/twin timer selection mode, return to run mode, set twn (twin time) → tim (timer) or tim (timer)
→ twn (twin timer) in timer/twin timer selection mode again, and return to run mode.
However, the output ON count monitor value (on-c, on1c, or on2c) and cumulative run time monitor (ot-c) are not initialized.
tim
Select either
Timer/Twin
operation using the UP1 Key (DW1 Key).
timer selection
Note: The H5CC is factory-set for timer operation.
H5CC
TIMER
1234
1234
twn
timer operation or twin timer
H5CC
33 33