Figure A-12.Vcr Setup Screen - Polycom ViewStation FX4000 User Manual

© Polycom, Inc. 2002
Select System Info > Admin Setup > Video/Camera > VCR. The
following screen appears:
Figure A-12. VCR Setup Screen
The VCR Setup screen lets you enable the following options:
VCR Record Source—You can set the VCR Record Source to the
following settings:
• Auto: When set to Auto, this option lets the VCR
automatically record the current speaker in a point-to-point
call.
• Near: When Near is selected, the VCR records the near-site
presentation.
• Far: When Far is selected, the far-site is recorded. Audio
from the near and far sites is always recorded.
VCR Audio Out Always On—When this option is enabled, the
system can operate with two VCRs, one for recording and one
for play. This also allows the use of the VCR audio out for room
audio applications where the near-site and the far-site audio are
required with any video input selected.
If you connect the same device to both the VCR input and VCR
output, then you may need to disable this feature to prevent an
audio feedback loop.
Appendix A - Screen Reference
Note
335