Upgrading Software Over Isdn (H.320) - Polycom ViewStation FX4000 User Manual

ViewStation FX/VS4000 User Guide

Upgrading Software over ISDN (H.320)

68
The software on your ViewStation FX or VS4000 can be upgraded
through an ISDN (H.320) video call from any other ViewStation FX
or VS4000 system.
You can perform a software update to the far site over your
V.35/RS-449, PRI, or BRI line during a call. Updating works best at
speeds of 512 Kbps and below.
If you want to update your software over IP (H.323), refer to
Upgrading Software over IP (H.323) on page
Do not power off the ViewStation FX or VS4000 during the software
update process. If you turn off a ViewStation FX or VS4000 during
the download process, your system reverts to its original software
version.
To upgrade your system over ISDN:
1. Place a video call to the system you want to upgrade.
2. Select System Info > Admin Setup > Security and write down
the passwords that appear on the Security screen of the site you
want to upgrade.
3. On the site sending the software, select System Info>Admin
Setup > Software/Hardware > Update to access the Far Site
Software Update screen.
4. Highlight the Start icon and press the SELECT button on the
remote control.
5. Enter the passwords that you wrote down in Step 2; highlight
the Start icon, and press the SELECT button on the remote
control to begin the upgrade process.
Note
65.
Caution
www.polycom.com