Entering Pri Video Numbers; Accessing Pri Information (T1 And E1) - Polycom ViewStation FX4000 User Manual

ViewStation FX/VS4000 User Guide

Entering PRI Video Numbers

Accessing PRI Information (T1 and E1)

134
PRI Setup. See Setting up PRI Options (T1 and E1), on page
PRI Status. See
138. This section also contains information about the channel
selection mechanism. See
Advanced PRI Setup. See
and T1), on page
Audio Quality Preference. See
Preference, on page
Advanced Dialing. See
Dialed in Parallel, on page
Dialing Speeds. See
For information about the initial PRI configuration screen, see
for the PRI Network Interface
Use the PRI Video Numbers screen if you need to change the area
code and PRI video number that you previously set up during the
out-of-box configuration. This screen also allows you to enter the
number that is needed to dial out if your system is on a PBX.
To access the PRI Video Numbers screen:
Select System Info > Admin Setup > Video Network > IMUX >
Numbers.
Most of the following settings displayed on this informational
screen are automatically detected by the ViewStation FX or VS4000
Selecting PRI Channels (E1 and T1), on page
PRI Channel Selection
Setting Advanced PRI Options (E1
140.
Setting Audio Quality
142.
Choosing the Number of Channels to be
143.
Selecting Dialing Speeds, on page
Note
in chapter 3.
136.
Information.
144.
Setup
www.polycom.com