Table of Contents
Advertisement
Connecting the Printer to a Network
56
5
If your UNIX system uses SunOS 4 or another BSD-
based variant, go to the next section.
If your system uses Solaris 2, follow the steps on
To set up printing on a UNIX system running SunOS 4 or another
BSD based variant:
1
On each workstation that will print to the printer, log in to
your UNIX host as the root user.
2
Create an entry for the printer in your /etc/printcap file.
The following is a sample printcap entry for the printer. Note that the
remote host name you enter in the rm line must exactly match the
name you entered in the /etc/hosts file.
KX-P8420q:\
:lp=:\
:rm=KX-P8420:\
:rp=xjprint:\
:lf=/var/spool/lpd/KX-P8420q/log:\
:sd=/var/spool/lpd/KX-P8420q:\
:mx#0:sf:sb
The spool directory KX-P8420q is specified here, and the directory
itself is created in
created in
step
everyone but a daemon user and daemon group); users cannot
modify or remove files other than their own.
It is possible to set up to two additional printer entries, one with the
rp name xjprint and one with the name xjhold. The rp name
indicates the KX-P8420 queue to which jobs are sent when you
print to the named printer.
A printer entry with the rp name xjhold routes all jobs to the
KX-P8420 Hold queue. Therefore, to print those jobs, they must be
moved to the Print queue or deleted using Fiery WebSpooler.
NOTE:
•
Printers without a hard disk drive and 32 MB of memory can not
use Print or Hold queues (rp name: xjprint and xjhold), they can
only receive print jobs over the Direct connection. Use the rp
name xjdirect if your KX-P8420 has no hard disk, or is configured
with less than 32 MB of memory.
step
3. Similarly, the log file is specified here and
4. The spool directory is write-protected (from
page
57.
Advertisement
Table of Contents
