Table of Contents
Advertisement
For Your Safety
General
Power source
Laser safety
Ozone release
12
Warning
•
To prevent fire or shock hazard, do not expose this product to rain or any
type of moisture.
Caution
•
Do not open covers and do not attempt to repair the unit yourself. Refer
servicing to qualified personnel.
Warning
•
The power source voltage of this unit is listed on the nameplate. Only plug
the unit into an outlet with the proper voltage.
•
When you operate this equipment, the outlet should be near the
equipment and accessible.
•
To ensure safe operation the AC cord supplied must be inserted into
standard three-prong AC outlet which is effectively grounded (earthed)
through the normal wiring.
•
The fact that the equipment operates satisfactorily does not imply that the
power point is grounded (earthed) and that the installation is completely
safe. For your safety, if in any doubt about the effective grounding
(earthing) of the power point, consult a qualified electrician.
•
If the plug cannot be inserted into the AC outlet, contact a licensed
electrician to replace the outlet with a properly grounded (earthed) one.
Do not defeat the purpose of the grounding (earthing) plug (ex. do not use
a conversion plug).
Caution
•
This printer utilizes a laser. Use of controls or adjustments or
performance of procedures other than those specified herein may result
in hazardous radiation exposure.
Warning
•
Make sure that the printer is installed in a well ventilated room so as not to
increase density of ozone in the air. Since ozone is heavier than air, it is
recommended that air at floor level be ventilated.
Advertisement
Table of Contents
