Table of Contents
Advertisement
Care and Maintenance
182
Message
Paper Feeder
Not installed
Parallel I/O
Buffer Overflow
PJL Operations
Failed
Press Enter to
Initialize Disk
Printing
Configuration
Printing
Font List
Printing
Test Page
Processing
PS Memory Full
PS Memory Full
Stored Data Lost
RAM Test Failure
Cycle Power
Scan Buffer Error
Cycle Power
Service (%s)
Cycle Power
TEST FAILED
UP/DOWN CANCEL
Corrective action/additional information
Install paper feeder.
Not enough memory to finish printing.
Error in PJL code. Resend print job to the
printer.
Press the Enter button to initialize a new
hard disk. This message will also appear if
the hard disk has malfunctioned, or if the
hard disk is the incorrect type. If this error
appears after cycling power to the printer,
contact an authorized service
representative.
Printer is printing the Configuration page.
Printer is printing the Font List page.
Printer is printing the Test Page.
Printer is receiving or processing a print job.
Not enough memory to finish printing.
Change printing resolution to 600 x 600 dpi if
you selected higher resolution.
or
Install additional memory in the printer.
Not enough memory to finish printing.
Change printing resolution to 600 x 600 dpi if
you selected higher resolution.
or
Install additional memory in the printer.
Cycle Power. If printer does not function
normally, call for service.
Cycle Power. If printer does not function
normally, call for service.
Firmware error. Contact an authorized
service representative.
Initial hardware test failed.
Call for service.
Advertisement
Table of Contents
