Absence Transfer - Aiphone AN-8000 Operating Instructions Manual

2.7.2. Absence transfer

When no response is made to a call to the station for a set period of time, the call is automatically transferred
to another designated station.
Calls received during conversation can be transferred. (Refer to
The station to which a Absence transfer is to be transferred can be set either by a dialing operation (see
below) or using the supplied AN-8000 Software program. (Refer to
Use the supplied AN-8000 Software program to enable or disable the Absence transfer or to set a calling
duration. (Refer to p. 5-27,
The station to which a call is to be transferred cannot be designated unless the Call forwarding function is
enabled.
Notes
Calls are not transferred under the following conditions:
• The designated station is set for Call forwarding.
• The designated station is not in standby mode
• The station set for Absence transfer is called as a representative or its associated member station of the
group.
Programming or erasure can be performed at your station.
[Programming]
[Erasure]
Note
The programmed contents by dialing operation are automatically saved into the exchange or IP
stations at midnight every day. If the exchange or IP station is turned off before completion of save,
such programmed contents are all cancelled.
p. 5-42.)
Call tone
No. 62
A call is automatically
transferred to another
designated station after
a set period of time
Function designation
number
+ 4 4 +
The originally called (your) station number
+ 4 4 +
Chapter 2: FUNCTIONS AND OPERATION
p. 2-12.)
p. 5-44,
Call
No. 11
Call tone
The designated transfer
destination station
No. 63
Transfer destination
station number
X X +
Y Y +
p. 5-48.)
6 2
(Confirmation tone)
(Confirmation tone)
2-15