Connector Connection; Mini-Clamp Connector Connection; Terminal Plug Connection - Aiphone AN-8000 Operating Instructions Manual

4.7. Connector Connection

4.7.1. Mini-clamp connector connection

Connect the mini-clamp connector supplied with the AN-8000EX or the AN-8000MI to a cable using a
commercially available tool (pliers).
Step 1. Cut off two-cable ends in equal length, and insert them
securely to a cover section (transparent side) of the
mini-clamp connector.
Note
Insert the cable without stripping the cable jacket.
For cables, refer to
Step 2. With a pair of pliers, lightly pinch the mini-clamp cover
and, after ensuring that the cable is securely inserted,
firmly squeeze on the cover.
Note
Squeeze on the mini-clamp cover until it is correctly
locked.
Step 3. Insert the wired connector (plug) into the exchange's connector (socket) until it locks into place.

4.7.2. Terminal plug connection

Step 1. Strip a cable jacket of approx. 7 mm (approx. 5 mm for the AN-8031MS only) from the cable end.
* Approx. 5 mm for the AN-8031MS
Step 2. Loosen the terminal screws and insert the cables.
p. 3-31, Type of Cable.
For cables, refer to
7 mm*
Note
Do not solder plate on exposed inner cables when using a
stranded wire.
Chapter 3: INSTALLATION & WIRING
Cover (transparent side)
Note: This figure shows the AN-8000EX.
p. 3-31, Type of Cable.
Cable
Rear panel
3-32