Paging - Aiphone AN-8000 Operating Instructions Manual

3.1.2. Paging

Paging calls can be made to up to 10 zones.
Use the supplied AN-8000 Software program to set the paging zones. (Refer to
Step 1. Press the Paging key, then [
Note
Enter a zone number with the same digit length (1 – 3 digits) set with the AN-8000 Software program.
Step 2. To select the zone numbers consecutively, press the [
Step 3. To terminate the zone selection, press the [
A paging tone is sounded in the selected zone(s).
Step 4. Page with the handset either lifted or in place.
Note
If the system's paging response mode has been set to designate the zone number (Refer to
notify the paged party of the response zone number (any one of the paged zones) in the paging
message.
Step 5. Either press the Clear key or replace the handset.
The paging is completed.
[Example paging to the zone 1, 23 and 105.]
1~3
0
0 2
1 0
4
or
5
C
] key followed by the desired paging zone number (1 – 160).
0 1
3
5
or
Chapter 2: FUNCTIONS AND OPERATION
p.
] key.
] key following the zone number.
Zone 1
Amplifier
Zone 23
No. 1000
No. 1002
Zone 105
Amplifier
5-52.)
p. 2-27.),
Speaker
No. 1003
No. 1004
Speaker
No. 2000
2-23