An-8000Mi Multi Interface Unit [Front]; [Rear] - Aiphone AN-8000 Operating Instructions Manual

5.2. AN-8000MI Multi Interface Unit
[Front]
1 2 3 4 5
00-05-F9-FF-00-00
1. Reset key [RESET]
Pressing this key reactivates the exchange.
2. LNK/ACT indicator [LNK/ACT] (Green)
Lights when connected to a network, and flashes
while transmitting or receiving data.
3. Status indicator [STATUS] (Red)
Continuously lights while data is written to an
internal storage medium (FlashMemory).
Flashes if there is a failure. (Refer to

[Rear]

6 7 8
6. Functional earth terminal [SIGNAL GND]
Be sure to ground this terminal unless the unit
connects to a PBX.
Note: This terminal is not for protective earth.
7. AC inlet
Connects the supplied power cord.
Note
If there is a danger of lightning strikes, insert an
appropriate surge arrester into the power line.
8. Cord clamp
Pass the power cord through this clamp to
ensure that the plug does not pull out when the
unit is mounted to a wall. (Refer to
9. Contact input terminals [CONTACT IN]
No-voltage make contact inputs.
Short-circuit current: 10 mA, Open-circuit
voltage: 12 V
10. Contact output terminals [CONTACT OUT]
Relay contact outputs.
Withstand voltage: 24 V DC, Control current:
Maximum 0.5 A
p. 8-6.)
9 10 11 12
p. 3-7.)
Chapter 1: GENERAL DESCRIPTION
4. Power indicator [POWER] (Green)
Lights when power is supplied to the unit.
5. MAC address
This is the address* 1
relationship of each exchange location to its MAC
address is established when setting the network
attributes, keep track of this relationship for later
use.
* The inherent address assigned to each network
1
component, expressed in 12-digit hexadecimal
notation.
M
13
11. Audio input level controls
[EXTERNAL SIGNAL 1, 2]
Use these controls to adjust the audio input
levels for channels 1 and 2 according to the input
sources.
12. Audio input terminal [AUDIO IN]
Includes audio inputs (maximum 0 dB*
kΩ, balanced) and contact inputs (no-voltage
make contact, short-circuit current: 10 mA, open-
circuit voltage: 12 V).
13. Audio output terminal [AUDIO OUT]
Includes audio outputs (maximum 0 dB*
600 Ω, balanced) and control outputs (relay
contact withstand voltage: 24 V DC, control
current: maximum 0.5 A).
14. PBX interface terminal [PBX IF]
Connects to the PBX exchange via the analog
E&M interface.
15. Network connection terminal [10/100M]
Connects to a 10BASE-T- or 100BASE-TX-
compatible network. (Ethernet RJ45 jack)
used by the unit. Since the
E M E
14 15
2 , over 10
, under
2
* 2 0 dB = 1 V
1-11