Connecting External Devices (Using The Option Connector); Mounting; Mounting Locations - Aiphone JP-4HD Installation & Operation Manual

Connecting external devices (using the option connector)

The 6-pin option connector of this station can be used with external devices.
CAUTION
To prevent shorts, cut unused lead wires at insulation.
•
Be sure to perform an operation check after the connection to check for miswiring.
•
To 6-pin
connector
1
External talk input
A foot switch can be connected to operate the TALK or END
function hands-free.
Input method N/O or N/C dry closure contact (start
signal only detection method)
Detection 100 mS or more
confi rmation time
Contact resistance During N/O dry closure: Less than 700 Ω
During N/C dry closure: At least 15 kΩ
Terminal short current Less than 10 mA
Voltage between Less than 5 V DC (when open between
terminals terminals)

MOUNTING

Mounting locations

• Install this station in a place where the screen is not exposed
to direct sunlight.
8
Black
FS
1
External talk input
Gray
FS+
White
BP2
3
External door release input 2
Blue
BP2+
Orange
BP1
2
External door release input 1
Yellow
BP1+
2, 3
External door release input 1, 2
Connect a door release button to each pair of these inputs.
Input method N/O or N/C dry closure contact (start
signal only detection method)
Detection 100 mS or more
confi rmation time
Contact resistance During N/O dry closure: Less than 700 Ω
During N/C dry closure: At least 15 kΩ
Terminal short current Less than 10 mA
Voltage between Less than 5 V DC (when open between
terminals terminals)
• Allow at least 15 cm (6") above and 25 cm (9") below center
of the mounting bracket for installation of the station.
15 cm (6") or more
25 cm (9") or more