Troubleshooting - Panasonic KX-TG2730S Operating Instructions Manual

Troubleshooting

Cordless Telephone
Problem
"No link to base.
Walk closer to
base and try
again." is displayed and
an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset and/or the
base unit does not ring.
The handset display is
blank.
You cannot store a name
and phone number in the
directory.
While programming or
searching, the handset
starts to ring and stops the
program/search.
You cannot make an
internal/external call with
the handset.
For assistance, please call: 1-800-211-PANA(7262)
Cause & Remedy
•You are too far from the base unit.
Walk closer to the base unit and try again.
•Plug in the AC adaptor.
•Raise the base unit antennas.
•Locate the handset and the base unit away
from other electrical appliances (p. 3).
•Walk closer to the base unit.
•Raise the base unit antennas.
•Press
on the handset to turn on the
Ü
Reception Booster feature (p. 29).
•The ringer volume is OFF. Set to HIGH or
MEDIUM or LOW (p. 19, 59).
•If more than one other user is using the
handsets and base unit, the handset/base
unit may not ring. Those users will hear
incoming call tones (p. 63) and the IN USE
indicator flashes quickly on the base unit.
•Charge the battery fully (p. 12).
•You cannot store an item in the directory while
the handset is in the talk, speakerphone,
intercom or Room Monitor mode, 2-Way Radio
mode or in the remote operation mode.
•Do not pause for over 60 seconds while
storing.
•To answer the call, press
again from the beginning after hanging up.
•You cannot make a call when the handset is
in the remote operation mode. Exit the mode
by pressing
(OFF)
•If the 2-Way Radio mode is on, turn it off
(p. 58).
or
(p. 71).
. Start
89