Inspection/Setup - MQ Power DCA300SSJU4F3 Operation Manual

ENGINE OIL
1. To check the engine oil level, place the generator on
secure, level ground with the engine stopped.
2. Remove the dipstick from its holder (Figure 36) and
wipe it clean.
DIPSTICK
Figure 36. Engine Oil Dipstick Location
3. Reinsert the dipstick, then remove the dipstick from
its holder. Check the oil level shown on the dipstick
(Figure 37).
Figure 37. Engine Oil Dipstick Level
4. Verify that the engine oil level is maintained between
the H and L markings on the dipstick as referenced in
Figure 37A.
5. If the engine oil level is low (Figure 37C), remove the
oil filler cap (Figure 38) and fill to a safe operating level
(max) as indicated by the dipstick (Figure 37A).
DCA300SSJU4F2/F3 60 HZ GENERATOR• OPERATION MANUAL — REV. #2 (04/18/22) — PAGE 39
3 0
0

INSPECTION/SETUP

NOTICE
When adding engine oil DO NOT overfill (Figure 37B).
6. Fill with recommended type oil as listed in Table 11.
Maximum oil capacity is 37 quarts (35 liters).
OIL FILLER
PORT
Figure 38. Engine Oil Filler Port
Table 11. Recommended Motor Oil
3 0
0