GENERATOR
This generator (Figure 7) is designed as a high quality
portable (requires a trailer for transport) power source for
telecom sites, lighting facilities, power tools, submersible
pumps and other industrial and construction machinery.
OPERATING PANEL
The "Operating Panel" is provided with the following:
ECU 845 Controller (Standard)
ECU 670 Gauge Unit Assembly
• Oil Pressure Gauge
• Water Temperature Gauge
• Charging Voltmeter
• Fuel Gauge
• Tachometer
• Generator Load
• DEF Gauge
Panel Light/Panel Light Switch
Hour Check Button
Auto Start/Stop Switch
Engine Speed Switch
Emergency Stop Button
Fuel Leak Detected Alarm Lamp
Basler DGC2020 HD Digital Controller (Option)
GENERATOR
The "Generator" can be configured with the following:
Engine Block Heater
PowerBalance™ (Option)
Battery Charger (Option)
PAGE 16 — DCA300SSJU4F2/F3 60 HZ GENERATOR • OPERATION MANUAL — REV. #2 (04/18/22)
GENERAL INFORMATION
CONTROL PANEL
The "Control Panel" is provided with the following:
Frequency Meter (Hz)
AC Ammeter (Amps)
AC Voltmeter (Volts)
Ammeter Change-Over Switch
Voltmeter Change-Over Switch
Hour Check Button
Voltage Regulator
3-Pole, 800-Amp Main Circuit Breaker
Panel Light
Panel Light Switch
"Control Box" (located behind Control Panel)
• Automatic Voltage Regulator
• Current Transformer
• Overcurrent Relay
• Starter Relay
• Voltage Change-Over Board
OUTPUT TERMINAL PANEL
The "Output Terminal Panel" is provided with the following:
Three 120/240V Output Receptacles (CS-6369), 50A
Three Auxiliary Circuit Breakers, 50A
Two 120V Output Receptacles (GFCI), 20A
Two GFCI Circuit Breakers, 20A
Eight Output Terminal Lugs (3Ø Power)
Ground Lug