MQ Power DCA300SSJU4F3 Operation Manual page 63

„ Press and hold the "REQUEST" button (Figure 91) until
the "REGEN ACTIVE" message is displayed on the
monitor and then release button.
REGEN ACTIVE MODE REQUEST
EMERGENCY RESERVE ENGINE
RUN MAY BE POSSIBLE.
TO ATTEMPT REGEN MODE:
PRESS THE REQUEST SOFT KEY.
EXIT
[REQUEST]
BUTTON
Figure 91. Regen Request
„ The regeneration process will start automatically, lasting
for at least 30 minutes. The Exhaust Temperature High
indicator (Figure 88) and Regeneration Needed Indicator
(Figure 89) will appear on both ECU-845/670 controllers
during the process and turns off when the regeneration
process has been completed.
DCA300SSJU4F2/F3 60 HZ GENERATOR• OPERATION MANUAL — REV. #2 (04/18/22) — PAGE 63
REQUEST
„ The Inhibit Regen indicator (Figure 92) wil be displayed
when regeneration will not occur.
NOTICE
The inhibit regeneration indicator appears in conditions
where it may be unsafe for elevating exhaust
temperatures.
Inhibit regeneration is only recommended when
absolutely necessary.
Figure 92. Inhibit Regen Indicator
MAINTENANCE