Setting By Dip Switches; Setting By Bs Buttons - Daikin SkyAir RZR-P Series Service Manual

Field Setting from Outdoor Unit
3.2

Setting by DIP Switches

The following field settings are made by DIP switches on PCB.
DS1-1
DS1-2
Cool/heat selector connection procedure
•
N Connect the cool/heat selector (optional accessory) to the terminals (A, B and C) on the
O Set the cool/heat selector switch DS1-1 from "OFF" (which is selected at the factory before
3.3

Setting by BS Buttons

The following settings are made by BS buttons on PCB.
There are the following 3 setting modes.
(1) Setting mode 1 (H1P OFF)
(2) Setting mode 2 (H1P ON)
(3) Monitor mode (H1P blinks)
Field Setting
DIP switch
No. Setting
ON
OFF (Factory
setting)
ON
OFF (Factory
setting)
Set the remote controller only when changing over the operation mode between cooling and
heating using the remote controller installed in the outdoor.
outdoor X2M Terminal board (A, B and C).
shipment) to "ON".
H1P
h
LED display
Initial status (when normal) : Also indicates during "abnormal".
Used to modify the operating status and to set program addresses, etc. Usually used in
servicing the system.
Used to check the program made in Setting mode 2.
Setting item
Cool/Heat
Used to set cool/heat changeover setting by remote
changeover
controller equipped with outdoor unit. (Note 1)
setting
Not used Do not change the factory settings.
A2P
DS1-1
switch knob
DS1 1 2
X2M
A B C
A B C
Cool/heat
selector
H2P H3P
h k
BS1 BS2 BS3 BS4
MODE SET RETURN TEST
Description
H4P H5P H6P
h h h
(Factory setting)
BS5
RESET
SiUS281117
H7P
h
81