Daikin SkyAir RZR-P Series Service Manual page 83

SiUS281117
2.3.2 Detailed Explanation of Setting Modes
Filter Sign Setting
If switching the filter sign ON time, set as given in the table below.
Setting
Contamination Light
Contamination Heavy
Electrical Heater Setting
Selection of the heater
The capacity of the electrical heater should be selected locally.
01: When the heating capacity of the heat pump is insufficient during heating, the heat pump is
03: If heating is insufficient in heat pump system alone, an electrical heater is used as the
Electrical Heater Step Setting
01: Controls ON/OFF of the heater in accordance with the thermostat step.
03: Without heater
Fan Speed Changeover when Thermostat is OFF
By setting to "Set Fan Speed," you can switch the fan speed to the set fan speed when the
heating thermostat is OFF.
 Since there is concern about draft if using "fan speed up when thermostat is OFF," you should
take the setup location into consideration.
On warming, the priority is given to this over "airflow OFF switch on thermostat OFF".
.This is used to correspond with the improvement of the electrical collection capability.
76
Filter Specs.
Mode No.
10(20)
Mode No. First Code No.
11(21)
stopped and heating operation is performed with an electrical heater. (It is switched by a hot-
water heating instruction from the outdoor unit.)
auxiliary electric heater.
Mode No. First Code No.
11(21)
Mode No. First Code No.
12(22)
Field Setting from Remote Controller
First Code Second
No. Code No.
01
0
02
Second Code No.
01
3
03
Second Code No.
01
5
03
Second Code No.
01
3
02
Lighting interval of the filter sign
(hours)
Ultra Long
Standard Long Life
Life Filter
200 hrs. 2,500 hrs. 10,000 hrs.
100 hrs. 1,250 hrs. 5,000 hrs.
Setting
Heat Pump lockout mode
Auxiliary electric heater +
Heat Pump lockout mode
Setting
With heater
Without heater
Setting
LL Fan Speed
Set Fan Speed
Field Setting