Daikin SkyAir RZR-P Series Service Manual page 36

Service Mode
2.3. Indoor Unit Status
2.4. Outdoor Unit Status 1. Unit No.
2.5. Forced Defrost
2.6. Error Display
2.7. Swap Unit No.
2.8. Addressed Sensor
Remote Controller
Maintenance Menu
10.FLOAT
11.T1/T2
12.Unit No.
13.Th1
14.Th2
15.Th3
16.Th4
17.Th5
18.Th6
2. FAN step
3. COMP
4. EV1
5. SV1
6. Th1
7. Th2
8. Th3
9. Th4
10.Th5
11.Th6
1. Forced defrost ON
2. Forced defrost OFF
1. Display Warning ON
2. Display Warning OFF
3. Display Error ON
4. Display Error OFF
1. Current Unit No.
2. Transfer Unit No.
 Unit No.: 0 - 15
Value
 Code
 Data
Item 2
Select the Unit No. you want to check.
Suction air thermistor
Heat exchanger thermistor
Discharge air thermistor
Select the Unit No. you want to check.
Fan tap
Compressor power supply frequency (Hz)
Degree that electronic expansion valve is open
(pls)
Solenoid valve ON/OFF
Outdoor air thermistor
Heat exchanger thermistor
Discharge pipe thermistor
Heat exchanger deicer thermistor
Heat exchanger gas pipe thermistor
Liquid pipe thermistor
Enables the forced defrost operation.
Disables the forced defrost operation.
Displays a warning on the screen if an error
occurs.
No warning is displayed.
Displays the error on the screen.
Displays neither errors nor warnings.
A unit No. can be transferred to another.
Select the Unit No. you want to check.
00: Remote controller thermistor (°F)
01: Suction air thermistor (°F)
02: Heat exchanger liquid pipe thermistor (°F)
03: Heat exchanger gas pipe thermistor (°F)
04: Indoor unit address No.
05: Outdoor unit address No.
06: BS unit address No.
07: Zone control address No.
08: Cooling/Heating batch address No.
09: Demand/low-noise address No.
The corresponding data will be displayed,
based on the Unit No. and Code selected.
SiUS281117
Remarks
—
—
—
29