Samsung AC BNPDBC Series User & Installation Manual page 24

Troubleshooting
Problem
Timer function is
not working.
Odors permeate in
the room during
operation.
Error is indicated.
Noise is generated.
Water is dropping
from the
connection part of
the drain pipe.
Indoor unit display
is blinking.
Heat is generated
from the control
panel on the indoor
unit.
Air conditioner is
not turning off.
24 English
Check if the air conditioner is off. Turn the air conditioner on and set the Timer
function.
When the timer is already set icon will appear on the indoor unit display, check to
see if the timer is already set.
Odor may permeate depending on the surrounding environment or operating
condition. Ventilate the indoor air or operate Fan mode for 1~2 hours if the odor does
not go away. (Parts of the air conditioner does not generate any odor)
Clean the air filter if it is dirty.
If the message ,
, , ,
indoor unit display, it means there is a problem so you should contact a service
center.
Depending on the status of the air conditioner usage (especially when the outdoor
temperature is below 20°C), noise can be generated due to changes in refrigerant
flow. You don' t have to worry since it is normal.
Water may be generated because of the temperature difference. It is normal.
Press the On/Off button and check if the display keeps blinking.
Turn off the auxiliary power switch and turn it on.
If the display keeps blinking after following above 2 instructions, contact the service
center.
When the air conditioner is on, little bit of heat may be generated from the control
panel. It is normal.
After turning off the air conditioner, it may generate breeze for certain period of
time for defrosting. It is normal.
Solution
, , , ,
, , , ,
, , , ,
, , blink on the