Table of Contents
Advertisement
Running Tests
Follow these steps to run a test from the Execute menu:
Press [tlor mtoselect Execute. You see the Execute
1.
menu, such as the following:
System Board
Numeric
System Memory
Diskette Drive A
Hard Disk Drive #l
Serial Port COMl
Serial Port COM2
Parallel Port LPTl
LPTl Printer Test
2.
Press m or m to highlight the device you want to test
and press IEnter You see the Repeat prompt:
How often to repeat test?
3.
If you want to run the test once, press I. To run the test
more than once, type the number of times you want to run
it and press I.
4.
If there is only one test for a device, the program begins
testing immediately. If there is more than one test for the
device, you see a submenu of test selections, such as the
following:
HARD DISK DRIVE(S) AND CONTROLLER
CHECK MENU
1 - Seek check
2 - Write, read check
3 - Read, verify check
4 - Run all above checks
0 - Exit
Coprocessor
Running System Diagnostics
1
A-5
Advertisement
Table of Contents
