Table of Contents
Advertisement
2.
Remove the four screws securing the internal drive housing
to the computer case, as shown below. Hold onto the
screws so they do not fall on the main system board.
3.
Grasp the underside of the housing and lift it up and out of
the computer. Be careful not to bump the housing into the
processor board or the main system board. Then set the
housing on your work surface.
4.
If you are removing your only IDE hard disk drive,
disconnect the cable connected to the hard disk drive socket
on the main system board. See page 5-2 to locate the socket.
5.
Now follow the instructions below to install or remove a
drive in the internal drive housing.
6-15
Advertisement
Table of Contents
