Table of Contents
Advertisement
Caution
Although your power supply is protected against excessive
power loads, you could still damage the main system board
if you install an option card that draws more power than the
limits shown in this table.
Installing an Option Card
Follow these steps to install an option card:
1.
Unpack the option card and adjust any switches or jumpers
on it, if necessary. Check the option card instructions and
any of the jumper and switch settings you viewed when
you ran the System Configuration program. (See Chapter 2
for more information.)
2.
Remove the retaining screw from the top of the metal option
slot cover and lift out the slot cover, as shown below.
Installing and Removing Options
5-5
Advertisement
Table of Contents
