If you are installing another type of Epson hard disk drive, the
jumpers may be in a different location, and there may be four
jumper positions instead of two.
Set the jumpers as necessary according to the the table below.
disk
jumper settings
Hard
drive
/Jumper I
One hard disk
drive
positions
HSP
X = jumper installed
You do not install any jumpers on the slave drive.
To install or remove an IDE drive in the internal drive housing,
see page 6-13 for instructions.
To install or remove an IDE drive in an upper drive bay, see the
next section for instructions.
Two hard disk drives
Master (Primary)
Slave (secondary)
6-5