7.
Align the hard disk drive cable connector with the drive
socket so the row in the connector with the blocked hole
lines up with the row in the socket with the missing pin, as
shown below. Then push in the connector.
Now go to step 9.
8.
If you are connecting diskette drive A, use the drive
connector labelled
cable. If you are connecting drive B, use the connector
labelled
connector labelled
Align the connector with the drive interface
divider in the connector lines up with the gap in the
interface, as shown in the following illustration. Then push
in the connector.
6-12
FDD1
FDD2.
If you installed a tape drive, use the
TAPE DRIVE ONLY.
blocked hole
on the end of the diskette drive
so that
the