Preparing The Machine; Installing The Side Bumpers; Procedure Description Qty; No Parts Required - Toro 78555 Operator's Manual

Procedure
11
12
13
Note:
Determine the left and right sides of the machine from the normal operating position.
1

Preparing the Machine

No Parts Required

Procedure
Perform the following procedure to prepare the
machine for attaching the blower and finishing kit.
1. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Repair all bent or damaged areas of machine
deck and replace any missing parts.
4. Clean the machine of any debris on the machine
deck or rear part of the machine to ease
installation.
2

Installing the Side Bumpers

Parts needed for this procedure:
1

Left bumper

1

Right bumper

2 Carriage bolt (3/8 x 1-1/4 inches)
6 Flange nut (3/8 inch)
Procedure
1. Remove the nuts and bolts holding the side
bumpers to the machine
Description
Bumper
Spacer
Locknut (5/16 inch)
No parts required
No parts required
-L position, and
OCKED
(Figure 5).
Qty.
2
Install the bumpers (for machines with
2
MyRide™ suspension system).
2
–
Adjust the parking brake.
–
Check the tire pressure.
Note:
Discard all nuts and only the 1 bolt
removed from each side.
2. Install the new left and right side bumpers with 2
carriage bolts (3/8 x 1-1/4 inches), 4 previously
removed carriage bolts, and 6 flange nuts (3/8
inch) as shown in
1. Flange nut (3/8 inch)
2. Right bumper
3. Use existing bolts
8
Use
Figure 5.
Figure 5
4. Left bumper
5. Bolt (3/8 x 1-1/4 inches)
g009214