Toro 78555 Operator's Manual page 20

CAUTION
The bagger adds a lot of weight to the rear
of the machine and may cause an unstable
condition which could result in a loss of
control.
The following table shows what weights are used
when a bagger is installed.
Front weights
used
48-inch machine 3
deck with bagger
52-inch machine 3
deck with bagger
60-inch machine 3
deck with bagger
72-inch machine 1
deck with bagger
(serial number
406294344 and
below)
72-inch machine 2
deck with bagger
(serial number
406294345 and
above)
1. Install caster weights on the front casters with a
clevis pin and a hairpin cotter
2. Install the nut onto each tap bolt and install the
tap bolts into each weight
3. Tighten the tap bolt so it touches the frame and
then tighten the jam nut against the weight.
Caster weights
used
0
0
2
2
2
(Figure 33).
(Figure 33).
1. Tap bolt (3/8 x 1-1/2
inches)
2. Nut (3/8 inch)
3. Caster weight
4. Install the weight-mount bracket under the
footrest with 2 carriage bolts (5/16 x 3/4 inch)
and 2 flange nuts (5/16 inch) as shown in
34).
1. Carriage bolt (5/16 x 3/4
inch)
2. Weight-mount bracket
5. Install the front weights on top of the footrest
(Figure 35).
6. Secure the front weights on top of the footrest
and to the weight-mount bracket with 6 bolts
(3/8 x 1 inch), 6 lock washers (3/8 inch), 3 flange
20
Figure 33
4. Hairpin cotter
5. Clevis pin
6. Install the tap bolt against
the frame and tighten the
nut.
Figure 34
3. Flange nut (5/16 inch)
g009224
Figure
g009226