Table of Contents
Advertisement
Figure 41
1. Bag
6.
Repeat for the other bag.
7.
Install the bag tab into the notch in the bagger
support frame.
Note:
Do this for both bags.
8.
Lower the bagger hood over the bags.
9.
Latch the bagger hood.
Clearing Obstructions from
the Bagger System
WARNING
When the bagger is in operation, the blower
can be rotating and cut off or injure hands.
• Before adjusting, cleaning, repairing
and inspecting the blower, and before
unclogging the chute, shut off the engine
and wait for all moving parts to stop.
Remove the key.
• Use a stick, not your hands, to remove an
obstruction from the blower and tube.
• Keep face, hands, feet, and any other
part of your body or clothing away from
concealed, moving, or rotating parts.
1.
Disengage the PTO and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Empty the bags.
g003357
2. Bottom handle
4.
Unlatch the lower tube.
5.
Remove the tubes from the bagger.
6.
Use a stick or similar object, not your hands, to
remove and clear the obstruction from the tube
assembly.
Note:
In most cases, the debris can be shaken
out of the tubes.
7.
If the blower assembly is plugged, unlatch the
bagger blower assembly, remove the belt, and
swing it open.
8.
Use a stick or similar object, not your hands,
to remove and clear the obstruction from the
blower assembly.
9.
After you remove the obstruction, install the
complete bagger system and resume operation.
Removing the Bagger
WARNING
Components around engine will be hot if the
machine has been running. Touching hot
components can cause burns.
• Do not touch engine components when
hot.
• Allow engine to cool before removing the
bagger.
1.
Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Unlatch the lower tube from the blower and
remove the tube from the blower assembly.
4.
Remove the tube from the bagger hood.
5.
Lower the mower deck to the lowest height-of-cut
position.
6.
Unlatch the belt cover over the mower-pulley
assembly.
7.
Remove the bagger belt from the mower-pulley
assembly.
8.
Open the blower assembly.
9.
Remove the blower assembly from the pivot
hole.
10.
If you are changing to side discharge mode,
ensure that the grass deflector is installed and
can be lowered into working position.
11.
Remove the hood and bag assembly.
24
Advertisement
Table of Contents
