Sony clie PEG-SL10 Operating Instructions Manual page 206

Troubleshoot ing – Frequent ly Asked Quest ions
I tried to perform a local HotSync operation, but it did not
complete successfully.
Try each of these in turn:
, Make sure that HotSync Manager is running. If HotSync Manager is
, Make sure that Local Serial is not selected in the HotSync Manager
, Check that the USB cable is properly connected to the USB connector
, Read the HotSync Log for the user account for which you are
, Make sure your CLIÉ handheld is securely connected to the USB
, Make sure that the gold-plated connectors on the USB cable and your
I cannot perform an IR HotSync operation.
, Make sure that the HotSync Manager is running and the Serial Port
, On your CLIÉ handheld, make sure that the HotSync application is
, Make sure that the IR port of your CLIÉ handheld is aligned directly
, IR HotSync operations do not work after you have received a low
, If you have problems using a specific speed, select Prefs, Connection,
Chapt er 6
Downloaded from:
running, exit, and restart it.
menu or the Palm Desktop for CLIÉ software menu.
of your computer.
performing a HotSync operation.
cable.
CLIÉ handheld are clean. Use a pencil eraser to clean the connectors.
for local operations is set to the simulated port for infrared
communication.
set to IR to a PC/Handheld.
opposite to, and within a few inches of, the infrared device of your
computer.
battery warning. Check the battery power of your CLIÉ handheld.
If necessary, replace the batteries with new ones (PEG-SL10) or
recharge your CLIÉ handheld (PEG-SJ20/PEG-SJ30).
IR to a PC/Handheld, Edit, then Details. Then select a lower speed in
the Details dialog box.
Additional information
https://www.usersmanualguide.com/
Continued on next page
206